April 28th, 2010, 5:44
seagate wrote:
to 7200.11, but 7200.12 ?
On Terminal press CTRL + Z:
F3 T>
F3 T> / 2
F3 2> Z
Spin down complete
Time elapsed msecs 0.147
F3 2>
Wait 5sec and remove the paper separating the Moto phone. Now screw just enough to make a link between PCB and hda (just be calm, relax!).
Then, press CTRL + Z again:
F3 2> U
Spin up Complete
Time elapsed 7.457 seconds (if you get this msg you used good until everything here)
F3 2> / 1
F3 1> N1
F3 1> / T
F3 T> <<<At this step you need to pull cable sata POWER OFF, wait 10sec HDD signal, and then back to POWER. (Not the PCB!).
When done, press CTRL + Z.
F3 T>
F3 T> I4, 1.22
F3 T>
F3 T> M0, 2.2 ,,,,, 22 <<<This command takes a little over a minute to complete!
WR max retries = 00, Max Rd retries = 00, T-Max ECC Level = 14, Max retries = 00C8 certification Rewrite
User format partitions 5% complete, Area 00, Pass 00, LBA 00004339, 00000080 ErrCode, Time elapsed 05 seconds 0 minutes
Users successfully format the partition - 0 minutes 05 seconds time elapsed
F3 T>
April 28th, 2010, 8:02
April 28th, 2010, 17:41
April 28th, 2010, 19:53
CK wrote:China PC3000 eh? That's very professional of you
April 29th, 2010, 1:59
May 3rd, 2010, 0:17
May 3rd, 2010, 11:33
May 10th, 2010, 1:50
May 10th, 2010, 2:03
Powered by phpBB © phpBB Group.