All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 28 posts ]  Go to page Previous  1, 2
Author Message
 Post subject: Re: Convert USB Toshiba MQ01UBD100 to SATA
PostPosted: December 31st, 2016, 2:07 
Offline

Joined: December 30th, 2016, 5:45
Posts: 1
Location: JAPAN
I am trying to get the corresponding ROM chip, but I can not peel off with Hot Air Pencil or soldering iron that I have now.
Everybody solder, How are you peeling off?


Top
 Profile  
 
 Post subject: Re: Convert USB Toshiba MQ01UBD100 to SATA
PostPosted: January 11th, 2017, 6:25 
Offline

Joined: January 6th, 2015, 6:54
Posts: 10
Location: Germany
Thanks Nick for sharing compatible PCB info.
today i have all data saved. i Have moved the rom-chip 602 to donor PCB :D :D

Frank


Top
 Profile  
 
 Post subject: Re: Convert USB Toshiba MQ01UBD100 to SATA
PostPosted: January 5th, 2020, 20:49 
Offline

Joined: January 5th, 2020, 20:45
Posts: 1
Location: United States
Nick_CT wrote:
This is probably old and obvious news, but just had to swap heads on a USB MQ01UBD100. The SATA PCB from the MQ01ABD100 head donor seemed a good match for SATA conversion.

USB PCB: G003250A

SATA PCB: G003138A

MCU: 88i9317-RAI2

Conversion worked fine.


So, i have one of USB MQ01UBD100, and found donor PCB SATA PCB from the MQ01ABD100. Do i still need to swap BIOS? Or can i it simply work by switching PCB?


Top
 Profile  
 
 Post subject: Re: Convert USB Toshiba MQ01UBD100 to SATA
PostPosted: January 6th, 2020, 3:57 
Offline
User avatar

Joined: June 16th, 2018, 12:09
Posts: 359
Location: Turkey
shahgm63 wrote:
Nick_CT wrote:
This is probably old and obvious news, but just had to swap heads on a USB MQ01UBD100. The SATA PCB from the MQ01ABD100 head donor seemed a good match for SATA conversion.

USB PCB: G003250A

SATA PCB: G003138A

MCU: 88i9317-RAI2

Conversion worked fine.


So, i have one of USB MQ01UBD100, and found donor PCB SATA PCB from the MQ01ABD100. Do i still need to swap BIOS? Or can i it simply work by switching PCB?


Must

_________________
A Recovery Service In Turkey . Veri Kurtarma Türkiye https://www.digitalverikurtarma.com
Donor Drives hdddonormarket.com


Top
 Profile  
 
 Post subject: Re: Convert USB Toshiba MQ01UBD100 to SATA
PostPosted: May 20th, 2020, 22:01 
Offline

Joined: May 20th, 2020, 21:57
Posts: 2
Location: United States
Hi, everyone,

I have a couple questions about this specific drive and if you think a new board would help.

Out of nowhere the drive just stopped working. It was fine one day, and the next it is just dead. The drive doesn't light up when I connect it to a computer, no sounds, OS doesn't recognize it. I tried different cables and different computers.

I was hoping that the interface is just bad and the drive is OK. I just had to do a data restore on a seagate drive and it cost $700. I really don't want to have to do it again.

Do you think this sounds like a bad board? I tried to remove it to make sure everyone was connected, but one of the screws is stripped and couldn't get the all off. Any tips on dealing with a stripped screw when they are so small?


Thanks for any help;


Top
 Profile  
 
 Post subject: Re: Convert USB Toshiba MQ01UBD100 to SATA
PostPosted: May 21st, 2020, 3:00 
Offline
User avatar

Joined: September 8th, 2009, 18:21
Posts: 12371
Location: Australia
There are two fuses near the USB port.

_________________
A backup a day keeps DR away.


Top
 Profile  
 
 Post subject: Re: Convert USB Toshiba MQ01UBD100 to SATA
PostPosted: May 21st, 2020, 22:19 
Offline

Joined: May 20th, 2020, 21:57
Posts: 2
Location: United States
Thanks for reply. I'm taking from that that you think one or both of the fuses might have blown?

Are they the two yellowish looking pieces that I have boxed out in green on the attached image?

Do they just pop out to replace? They look like they were soldered in.

Thanks again

Attachment:
T100011.jpg
T100011.jpg [ 103.73 KiB | Viewed 292 times ]


Top
 Profile  
 
 Post subject: Re: Convert USB Toshiba MQ01UBD100 to SATA
PostPosted: May 21st, 2020, 23:35 
Offline
User avatar

Joined: September 8th, 2009, 18:21
Posts: 12371
Location: Australia
Here they are:


Attachments:
fuses.jpg
fuses.jpg [ 40.1 KiB | Viewed 281 times ]

_________________
A backup a day keeps DR away.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 28 posts ]  Go to page Previous  1, 2

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 69 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group