Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
January 19th, 2016, 19:42
Ace Labs seem to have left off the highlights for the ground points to convert the 701675 USB board to a SATA board. Can someone advise me of the correct points (fzabkar ?
January 19th, 2016, 19:57
you kidding ? right ?!
January 19th, 2016, 20:26
jermy wrote:you kidding ? right ?!
No. I do see lots of ground points, but this is the first one of these I have done. I may look stupid asking these questions, but I want to make sure I do not lose, or gamble with my clients data. If any of these points can be used that's all I want confirming
January 19th, 2016, 20:58
use any GRD you like on the PCB
January 19th, 2016, 21:36
January 19th, 2016, 21:37
Use the neighbors house ground.....
January 19th, 2016, 22:08
Rather use the neighbors power...
Powered by phpBB © phpBB Group.