Hello everyone,
Before we start, I wanted to let you all know I have already read the other threads on this particular drive. I am aware of the PCB compatibility issues between Pebbleb and Spyglass.


For these particular drives, does anyone know where to solder in order to get boot ROM access via com port? Soldering ROMs on WD drives has caused all kinds of issues in the past for me so I prefer to avoid doing it.

So far I have not found reliable information related to this subject. There are some photos of people soldering wires onto certain contacts near the USB controller. However, when trying it for myself it does not work...

What are your thoughts on this? Any suggestions? Has anyone found a Spyglass SATA PCB compatible with this drive?

Thank you kindly in advance.

Regards,
Omega

_________________
Remember, take your time. Be persistent. If you have doubts stop. Check, then proceed again.

I forgot to add photos.

If I have to do the SATA pinouts. What caps do I remove? I have an idea as to which ones but want to confirm.

_________________
Remember, take your time. Be persistent. If you have doubts stop. Check, then proceed again.

Deleted post

_________________
Rescue IT Datarecovery service Sweden
Rescue IT Dataräddning Göteborg AB
http://www.rescue-it.se

_________________
A backup a day keeps DR away.

Hi frank,
Its to be noted that atleast some time is needed before drive goes to kernel mode ,I do not have experience in this particular board but generally its 5 minutes to 6 for other usb boards

_________________
Regards
Amarbir S Dhillon , Chandigarh Data Recovery Labs [India]
Logical,Semi Physical And Physical Data Recovery
Website-> http://www.chandigarhdatarecovery.com

That helps at least with that part. Thank you. I may need further assistance but for now this gets me started at least.

Edit: That did not give me terminal access....

_________________
Remember, take your time. Be persistent. If you have doubts stop. Check, then proceed again.