Hello,
I have big problem with Seagate ST9500325AS hard drive. Yesterday I was not be able to boot up Windows and then I tried to rescue data.
The drive is normally detected by BIOS, Linux distros (like SystemRescueCd, Parted Magic) and MHDD.
MHDD can show ID (F2) and EID (Shift+F2)
Code:
ST9500325AS LBA: 976,711,055 BIOS: 81H
SN: 5VEJEK6Z FW: 0006SDM2 CACHE: 8192 KB
Size = 476938 MB
smartctl on Linux and MHDD can read SMART attributes (F8) - see below
Code:
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 110 089 006 Pre-fail Always - 92512969
3 Spin_Up_Time 0x0003 098 098 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 092 092 020 Old_age Always - 8625
5 Reallocated_Sector_Ct 0x0033 001 001 036 Pre-fail Always FAILING_NOW 2041
7 Seek_Error_Rate 0x000f 086 060 030 Pre-fail Always - 4762335220
9 Power_On_Hours 0x0032 087 087 000 Old_age Always - 12083
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 092 092 020 Old_age Always - 8655
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 709
188 Command_Timeout 0x0032 100 098 000 Old_age Always - 8590065680
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 074 058 045 Old_age Always - 26 (Min/Max 26/26)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 731
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 76
193 Load_Cycle_Count 0x0032 059 059 000 Old_age Always - 82122
194 Temperature_Celsius 0x0022 026 042 000 Old_age Always - 26 (0 11 0 0 0)
195 Hardware_ECC_Recovered 0x001a 052 044 000 Old_age Always - 92512969
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 6
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 6
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0
MHDD can read LBA from 0 to ~6280000 without delays and then I get x UNC (badsector). After this I can see only ! ABRT. Drive is not accessible anymore. To get access again the drive has to be power cycled.
After this I started scan from LBA 6300000 and again I get x UNC (badsector) before ~32100000. Next scan I started at 32100000 and it the same thing as before.
When I tried to make 1:1 copy by ddrescue to another good HDD.
Can anyone help with this?
English isn’t my native language, so please excuse any mistakes.