April 11th, 2018, 23:39
April 12th, 2018, 10:39
April 12th, 2018, 11:25
April 12th, 2018, 11:38
labtech wrote:How "dead" exactly is it?
What does the drive do on power up (spin, no spin, buzzes, smokes, etc)?
April 12th, 2018, 11:43
April 12th, 2018, 11:45
pixelbat wrote:labtech wrote:How "dead" exactly is it?
What does the drive do on power up (spin, no spin, buzzes, smokes, etc)?
Last week my computer started getting BSOD. Then after about 3 times of that, smoke started coming from this drive. It's not my main drive, but something I stored old projects on. I'm pretty sure it's the PCB. There is a burnt plastic smell around the power/sata plugs.
April 12th, 2018, 11:54
data-medics wrote:If you have a multimeter check the two TVS diodes where the power supply connects to the drive:
If either one is a dead short circuit measured both directions it's burned.
April 12th, 2018, 11:56
unknown wrote:pixelbat wrote:labtech wrote:How "dead" exactly is it?
What does the drive do on power up (spin, no spin, buzzes, smokes, etc)?
Last week my computer started getting BSOD. Then after about 3 times of that, smoke started coming from this drive. It's not my main drive, but something I stored old projects on. I'm pretty sure it's the PCB. There is a burnt plastic smell around the power/sata plugs.
Match PCB # then transfer ROM from patient to donor. Should be OK if there's no further damage to pre-amp.
Good luck
April 12th, 2018, 12:48
April 12th, 2018, 14:36
rogfanther wrote:No reading, as in open circuit, or it reads the same as when you touch the points of the multimeter probes to each other ?
April 12th, 2018, 14:39
April 12th, 2018, 16:46
pixelbat wrote:rogfanther wrote:No reading, as in open circuit, or it reads the same as when you touch the points of the multimeter probes to each other ?
I'm no multimeter expert. So, I'm probably doing something wrong. In diode mode I get voltage in both directions on the left diode, and no voltage in either direction on the right diode.
Powered by phpBB © phpBB Group.