May 21st, 2018, 1:52
May 21st, 2018, 8:40
May 21st, 2018, 8:55
labtech wrote:Not a PCB problem
May 21st, 2018, 9:07
jazvic wrote:F3 T>/2
F3 2>Z
Spin Down Complete
Elapsed Time 6.035 secs
[Remove the shorting and give following command]
F3 2>U
HighPowerMode
ExecuteSpinRequest
Spin Up Complete
Elapsed Time 3.573 secs
F3 2>/
F3 T>m0,2,2,,,,,22
Max Wr Retries = 00, Max Rd Retries = 00, Max ECC T-Level = 16, Max Certify Rewr
ite Retries = not supported
User Partition Format Successful - Elapsed Time 0 mins 00 secs
F3 T>/1
F3 1>N1
Clear SMART is completed.
F3 1>
[disconnect the power, wait couple seconds and connect again]
Rst 0x08M
(P) SATA Reset
jazvic wrote:If i use the commands:
V1, V2, V4, V10 and V40 i have information back and none of them empty.
May 21st, 2018, 12:44
jermy wrote:jazvic wrote:F3 T>/2
F3 2>Z
Spin Down Complete
Elapsed Time 6.035 secs
[Remove the shorting and give following command]
F3 2>U
HighPowerMode
ExecuteSpinRequest
Spin Up Complete
Elapsed Time 3.573 secs
F3 2>/
F3 T>m0,2,2,,,,,22
Max Wr Retries = 00, Max Rd Retries = 00, Max ECC T-Level = 16, Max Certify Rewr
ite Retries = not supported
User Partition Format Successful - Elapsed Time 0 mins 00 secs
F3 T>/1
F3 1>N1
Clear SMART is completed.
F3 1>
[disconnect the power, wait couple seconds and connect again]
Rst 0x08M
(P) SATA Reset
bad isea using the procedure mentioned above, when you say:jazvic wrote:If i use the commands:
V1, V2, V4, V10 and V40 i have information back and none of them empty.
May 21st, 2018, 19:00
jazvic wrote:jermy wrote:jazvic wrote:Now regarding the codes: V1, V2, V4, V10 and V40, according to this list:
https://www.data-medics.com/forum/seaga ... -t901.html
Are only for scan not to modify.
So please help me to understand why is bad idea?
Thank you in advance
June 2nd, 2018, 13:09
November 1st, 2019, 7:44
November 2nd, 2019, 13:11
November 3rd, 2019, 12:09
scottsen11 wrote: ctrl + c (spin down) command.
Powered by phpBB © phpBB Group.