Hello,
I have a USB WD drive that had a problem in PCB, the customer bought a new drive with same model ID/PCB ID. I moved ROM the the good PCB and drive start working correctly.
The customer left me the HDA (of the new drive), I bought the same PCB REF:
2060-800041-003 REV P1 and I moved ROM to the new bought PCB.
Now, the drive spin well, Reaches readiness and run in Normal mode. it can read Model/Capacity/SA SPT, but doesn't read ROM. here what it shows in terminal:
Code:
Techno mode key......................... : Ok
Debug Stop Code reading................. : No data been read
RAM:
SA HDD has unknown capacity. SA CHS access may operates wrongly
HDD Info reading........................ : Ok
Heads number............................ : 10
Cyl Count............................... : 384
Zone allocation table................... : Ok
SA SPT.................................. : 2140
ROM:
Read ROM................................ : HDDs ROM reading error; unexpected error: Data request error; unexpected error: Abort command : No Additional Sense Information
Service area:
SA dir reading (ID)..................... : Ok
SA Access............................... : Copy 0,Copy 1
Configuration reading................... : Module ID 02 reading error; unexpected error: Data request error; unexpected error: Abort command : No Additional Sense Information
what could be the problem, Security or ROM? is there a way to correct this to have a Working drive?
Thanks in advance for your help,