May 15th, 2019, 14:03
May 16th, 2019, 2:21
May 16th, 2019, 4:09
May 16th, 2019, 15:21
May 16th, 2019, 19:26
May 20th, 2019, 9:09
May 21st, 2019, 17:56
June 16th, 2019, 5:58
June 16th, 2019, 13:27
June 16th, 2019, 16:38
June 17th, 2019, 7:34
...doing thigns correctly THE FIRST TIME
June 17th, 2019, 10:53
.... power the drive on with the terminal connected and POST the LOG that the drive output to TTL/terminal software at power up ... Goes without saying open the terminal first and power the drive later.
June 17th, 2019, 13:56
June 18th, 2019, 6:59
open the terminal software like Hyperterminal
June 20th, 2019, 9:58
June 21st, 2019, 3:22
oneRd wrote:Sorry, I didn't mean to kill you enthusiasm with my "think out loud ignorance"
I run Victoria. SMART: unkn
June 21st, 2019, 14:52
Make sure you use an up to date version as is here: http://files.hddguru.com/download/Softw ... ia473b.zip
Or you can set the sata port to compatibility/ide mode in the motherboard bios.
June 22nd, 2019, 4:54
June 22nd, 2019, 9:03
June 22nd, 2019, 11:48
dick wrote:You connected the drive via usb and it was no good.
Now you have to connect the drive to a motherboard sata port and run Victoria again.
Powered by phpBB © phpBB Group.