Hello.
...Is what I wish my Seagate PCB would say. It doesnt. It says nothing.
I've followed a general guide of updating the firmware, so i made a small paper stopper for the heads connector. (must confess I dont know why)
I connected it to my USB to serial interface, checked the interface with TX&RX loopback. It checks out.
I checked that I have Tx to Rx and Rx To Tx. *I also tried the other stupid way, and it made me feel special.
However, In hyperterminal I'm getting CONNECTED in the bottom left of the screen. I guess I'm supposed to ctrl-z which I've done to the extent that the Z now is a bit more indented than the other keys.
Connection is set to 38400 bps, no parity bit and no flow control it's a seagate barracuda 3TB (the failing type).
Am I missing something here?
- Attachments
-
- 2020-02-17.png (9.73 KiB) Viewed 2531 times
-
- 2020-02-17 (1).png (8.01 KiB) Viewed 2531 times