Joined: December 31st, 2007, 3:09 Posts: 7
|
I have a ST1000DM003 That was running very slowly until it stopped. At that time it was detected by BIOS. I have replaced the PCB and swapped the EPROM, CMOS, Flash chip. The drive The drive then ran again for a very short time fetching data. It stopped again. and was no longer detected by bios. I was told it may be heads. It has a single platter I ordered a head swapping tool and donor drive and swapped heads.
The drive was now detected by bios but HDDSuperclone froze when selecting the drive.
I purchased a TTL serial adapter and hyperterm.
On power up I get Spin Up SpinOK TCC:001B
(P) SATA RESET.
Any suggestions?
Thanks Tom
|
|