All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: ST1000DM003 not showing in BIOS have serial access.
PostPosted: May 22nd, 2020, 9:45 
Offline

Joined: December 31st, 2007, 3:09
Posts: 7
I have a ST1000DM003 That was running very slowly until it stopped. At that time it was detected by BIOS.
I have replaced the PCB and swapped the EPROM, CMOS, Flash chip.
The drive The drive then ran again for a very short time fetching data. It stopped again. and was no longer detected by bios.
I was told it may be heads. It has a single platter I ordered a head swapping tool and donor drive and swapped heads.

The drive was now detected by bios but HDDSuperclone froze when selecting the drive.

I purchased a TTL serial adapter and hyperterm.

On power up I get
Spin Up
SpinOK
TCC:001B

(P) SATA RESET.

Any suggestions?


Thanks Tom


Top
 Profile  
 
 Post subject: Re: ST1000DM003 not showing in BIOS have serial access.
PostPosted: May 22nd, 2020, 14:20 
Offline

Joined: July 2nd, 2011, 14:16
Posts: 399
Location: England
it must be some kind of firmware corruption problem. I don't think changing pcb and all that was needed. might be a bad sectors causing problems.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: Google [Bot] and 56 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group