June 20th, 2016, 17:38
June 20th, 2016, 18:22
June 20th, 2016, 18:39
thatdellguy wrote:Screws under front sticker...
June 20th, 2016, 18:45
June 20th, 2016, 19:31
fzabkar wrote:http://www.anandtech.com/show/6733/kingston-ssdnow-v300-review
June 20th, 2016, 20:26
ddrecovery wrote:Any advice on how to crack open this case? No screws in this one.
ddrecovery wrote:Thanks, I see its SandForce
June 20th, 2016, 20:54
June 20th, 2016, 20:57
June 20th, 2016, 21:18
June 20th, 2016, 21:34
June 21st, 2016, 16:24
fzabkar wrote:I can help you with the "not-so-obvious PCB issues" if you upload detailed photos of both sides. For example, there is a 5V e-fuse near the SATA power pins.
PCB protection devices - Electronic Fuse:
http://www.hddoracle.com/viewtopic.php? ... 8872#p8872
June 21st, 2016, 17:17
June 21st, 2016, 20:36
fzabkar wrote:I would start by measuring the +5Vin and +5Vout voltages at the 5V e-fuse.
Then I would measure the regulator voltages at V1, V2, V3 and V4.
I presume there would be a serial interface that you could test with the appropriate tool. That should tell you whether the controller is alive.
APW8804, Anpec, synchronous buck converter with high and low side MOSFETs, 3A, 2.6V - 6V in:
http://www.anpec.com.tw/ashx_prod_file. ... PW8804.pdf
http://www.wpgholdings.com/uploads/bu/b ... 8804a4.pdf
June 22nd, 2016, 16:19
June 22nd, 2016, 17:37
June 22nd, 2016, 17:51
[ROM] PORRST
[ROM] Chip ID 0x200026BB
*** ROM Rev 20D Dec 20 2010 Build 288571 ***
June 22nd, 2016, 18:10
June 22nd, 2016, 19:06
June 22nd, 2016, 19:25
June 22nd, 2016, 19:34
Powered by phpBB © phpBB Group.