CompactFlash, SD, MMC, USB flash storage. Anything that does not have moving parts inside.
February 12th, 2017, 7:50
OCZ Arc 100 ssd 240gb with 1.01 firmware.
This ssd drive appears to be working in read only mode.
I have tried connecting it to various motherboards using both ahci and ide modes.
Drive is correctly seen by the bios but causes very slow boot (if at all).
I had to connect power after system boot to access data.
All data was easily retrieved.
I am asking if this drive can be fixed or is it just trash?
February 12th, 2017, 9:27
try to RE-FLASH the FW and see how it goes.
Note: Backup your files 1st.
February 12th, 2017, 16:20
Could we see a SMART report?
February 13th, 2017, 7:10
OCZ-ARC100 A22L1061507007256
-------------------------------------------------------------------------
ID Name Value Worst Tresh Raw Health
-------------------------------------------------------------------------
5 Reallocated sector count 0 0 0 0 •
9 Power-on time 100 100 0 5750 •••••
12 Start/stop count 100 100 0 1174 •••••
171 unknown attribut 100 100 0 80919376 •••••
174 unknown attribut 100 100 0 153 •••••
195 Hardware ECC recovered 100 100 0 0 •••••
196 Reallocated event count 100 100 0 0 •••••
197 Current pending sectors 100 100 0 0 •••••
208 Spin buzzes count 100 100 0 136 •••••
210 Vibration during write 100 100 0 0 •••••
224 Load friction 100 100 0 1 •••••
233 unknown attribut 96 96 0 96 ••••
241 unknown attribut 100 100 0 7231 •••••
242 unknown attribut 100 100 0 8434 •••••
249 unknown attribut 100 100 0 408075480 •••••
Powered by phpBB © phpBB Group.