HDD GURU FORUMS http://forum.hddguru.com/ |
|
SD Monolith Question http://forum.hddguru.com/viewtopic.php?f=10&t=36358 |
Page 1 of 1 |
Author: | arvika [ January 27th, 2018, 3:39 ] |
Post subject: | Re: SD Monolith Question |
It is pads for nand connection so since you not need read directly from nand, and card still working, you need regenerate only traces which goes to connector or that are connect to vias. And it should work. |
Author: | ddrecovery [ January 27th, 2018, 10:26 ] |
Post subject: | Re: SD Monolith Question |
I tried simply mounting the card, but had only 30mb showing, so I presume the card was using the on board controller from the USB. I tried simply mounting the card. Would that affect anything? |
Author: | arvika [ January 27th, 2018, 14:21 ] |
Post subject: | Re: SD Monolith Question |
Usually if card shows small capacity like 8MB, 30MB it means that it not see nand. |
Author: | HaQue [ January 28th, 2018, 9:22 ] |
Post subject: | Re: SD Monolith Question |
ddrecovery wrote: I tried simply mounting the card, but had only 30mb showing, so I presume the card was using the on board controller from the USB. I tried simply mounting the card. Would that affect anything? Yes, One vendors garbage is another vendors re-purposed NAND(Refurbished is too strong a word) I would agree with this, it is basically a NAND chip in a SD Card package. Once you fix the traces from pads to internals you should get a read of NAND, unless internal bonds also broken. Washing should have had no effect. |
Author: | ddrecovery [ January 28th, 2018, 14:29 ] |
Post subject: | Re: SD Monolith Question |
Thanks guys. I will let you know how I get on. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |