All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: OCZ Agility3 shortcut
PostPosted: February 9th, 2018, 11:18 
Offline

Joined: August 29th, 2013, 4:28
Posts: 15
Location: Hungary
Hello guys!

Could you help or advise me something to figure out what's wrong with this motherboard?
There is a shortcut somewhere. On the first picture the, I marked a resistor, a few condensators all over these and all next to of the NANDs are shorted and shows ~ 4-5 Ohms of resistance. The second picture shows exact voltages from a good ssd. (measured with a Chinese multimeter :D )
The voltage regulator is a http://www.ti.com/lit/ds/symlink/tps652510.pdf.
The 1,0x Volts are needed for the contoller and the 3,0x for the NANDs.
In the defective SSD these values about 0,3 and 0,5 Volts, the device itself consumes about 3 Watts and the contoller becames really hot within a few seconds.

Thanks in advance


Attachments:
IMG_20180209_125121.jpg
IMG_20180209_125121.jpg [ 3.26 MiB | Viewed 4740 times ]
TPS652510.jpg
TPS652510.jpg [ 1.44 MiB | Viewed 4740 times ]
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 10 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group