| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| Sandisk Monolith Data Line Question http://forum.hddguru.com/viewtopic.php?f=10&t=37796 |
Page 1 of 1 |
| Author: | ddrecovery [ December 11th, 2018, 19:37 ] | ||
| Post subject: | Sandisk Monolith Data Line Question | ||
This SD Card was water damaged and has some corrosion. We can see that several of the pads were severed from the via's. All but one of the lines can be read through the via or other contact points. However the data line I have marked on the picture is dead. Is there anyway to tap into this data line from a different point? I have tested it all the way to the bottom of the chip and it is dead.
|
|||
| Author: | fzabkar [ December 11th, 2018, 20:17 ] |
| Post subject: | Re: Sandisk Monolith Data Line Question |
Are you able to access the card in a different mode, eg SPI bus mode or One-bit SD bus mode? https://en.wikipedia.org/wiki/Secure_Digital |
|
| Author: | arvika [ December 12th, 2018, 0:49 ] |
| Post subject: | Re: Sandisk Monolith Data Line Question |
SD v13 from my DB http://odzyskiwanie-danych.com.pl/image ... arvika.jpg It is 8-bit memory, so this pad is not necessary for recovery. Check continuity from pads to vias for all used memory signals. If some is broken connect directly to via. If not work, memory is damaged or you make some mistake. |
|
| Author: | ddrecovery [ December 12th, 2018, 12:10 ] |
| Post subject: | Re: Sandisk Monolith Data Line Question |
Thanks Guys. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|
