February 5th, 2024, 5:52
February 14th, 2024, 17:18
March 23rd, 2024, 7:13
March 23rd, 2024, 7:25
March 23rd, 2024, 12:10
March 23rd, 2024, 12:36
fzabkar wrote:Has anyone bought one of @Bolo's adaptors? I always wonder about the economics of buying an adaptor that may only have a one-time use.
March 23rd, 2024, 17:29
Lardman wrote:fzabkar wrote:Has anyone bought one of @Bolo's adaptors? I always wonder about the economics of buying an adaptor that may only have a one-time use.
It takes (me) 20-30 mins to solder a card up by hand I figure ROI in around 12 cases.
March 24th, 2024, 6:18
The available adapters tend to be for pinouts that are already known and included in the tool databases but if there's an unknown pinout on a known layout they could also be used to connected to the LA rather than a breakout board. It's why the datalabs one from Apex although less polished I think is actually good value, I'm sure there are 3d printed version of similar homebrew solutions that have been made in-house all over the place.fzabkar wrote:Perhaps you should factor in the cost of pinout discovery, assuming that you don't do this in your spare time.
March 24th, 2024, 16:27
Sythnexus wrote:Hello, I am not active in that business myself, but I gave my SD Card while travelling in Vietnam to an office to do it for me. Sadly they couldnt find out the pinout, so I was hoping to get help here . Do you know for how much I could get the pinout for?
March 30th, 2024, 8:26
April 4th, 2024, 2:26
Sythnexus wrote:Would you be willing to sell it for me?
Powered by phpBB © phpBB Group.