Dear : all (Mr. Pepe, Amarbir, PCimage, ......)

I have a USB drive, It is detect by WinXP but the USB X:\is not accessible and when I click the USB X:\ appear message :The request could not be performed because of an I/O device error. I can get data back 90% with GDB or ER, I run GDB with Ignore or skip read error.

Please help me to know where is the problem (IC RAM, Controller, Voltage regulator, cristall, bad joint solder or .....) so I can get 10% remain data.

Thanks

Hi

I think the problem is caused by instable or damaged pages. I am not sure U can get anything out from those pages without reading the flash memory directly.

pepe

_________________
Adatmentés - Data recovery

Thanks Mr. Pepe

But It is true, I run Getdataback and after few minute appear message : read error and I ignore all read error untill finish and I can see data and copy to another media. Maybe I am lucky.

At least better than if nothing could be read

pepe

_________________
Adatmentés - Data recovery