View topic - 7200.10 criteria for PCB swap

Main » Forums home » Research and development

All times are UTC - 5 hours [ DST ]

Forum rules

Please do not post questions about data recovery cases here (use this forum instead). This forum is for topics on finding new ways to recover data. Accessing firmware, writing programs, reading bits off the platter, recovering data from dust...

7200.10 criteria for PCB swap

Page 1 of 1

[ 2 posts ]

Previous topic | Next topic

Author

Message

shaun

Post subject: 7200.10 criteria for PCB swap

Posted: October 31st, 2009, 9:54

Joined: July 8th, 2006, 6:18
Posts: 222

Hi all,

I've a 7200.10 here with burned combo and 12V TVS. Before I evaluate my chances that the preamp has survived, I'd like to make sure the criteria for swapping PCBs. I have one from a drive with the same model number, but the Agere chip has a slightly differenz number. Would I have to swap the 512kByte serial flash?

Top

N.C.

Post subject: Re: 7200.10 criteria for PCB swap

Posted: October 31st, 2009, 11:10

Joined: March 28th, 2008, 7:52
Posts: 1466
Location: Europe, Hungary

You need to match the PCB version, and yes, you should swap the ROM as well.
Different MCU is a bad sign.

Top

Page 1 of 1

[ 2 posts ]

Main » Forums home » Research and development

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 42 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum