In-depth technology research: finding new ways to recover data, accessing firmware, writing programs, reading bits off the platter, recovering data from dust.
Please do not post
questions about data recovery cases here (use this forum
instead). This forum is for topics on finding new ways to recover data. Accessing firmware, writing programs, reading bits off the platter, recovering data from dust...
April 19th, 2013, 5:25
Hi all, a couple of questions if someone has time to answer them;
I am wanting to test a quantity of drives that do not spin up or are not detected in the BIOS
I have the Seagate Diagnostic Commands and I have been reading the Seagate BSY tutorials and obtained a USB to serial connector but no matter how I input 'Ctrl z' im not getting a response in the Terminal any Terminal ie: Cutecom, gtkTerm etc. I have connected the RX and TX and can get an echo of any commands I type so the cable itself appears to be working, Do I hold down the 'Ctrl' Key and tap 'z' is that correct ?
So I have a large quantity 60+ Western Digital and Seagate hard drives some of which have had the PCB's removed, I would like to test them before selling them on, can I run any tests on the PCB's that are not connected to a drive ? and if so is there a Seagate Diagnostic Command (DisplayActiveStatus ?) to give me a general idea of the health of a PCB, something I could mention to potential customers so they know they are working PCB's.
Powered by phpBB © phpBB Group.