May 8th, 2015, 0:58
sata_task started: S= DRIVE_IDLE_STATE
drive state: DRIVE_SEND_ERROR_STATUS_STATE
May 9th, 2015, 9:38
HaQue@kali:~# telnet localhost 4444
Trying ::1...
Trying 127.0.0.1...
Connected to localhost.
Escape character is '^]'.
Open On-Chip Debugger
>
>jtag arp_init-reset
JTAG tap: auto0.tap tap/device found: 0x10147043 (mfg: 0x021, part: 0x0147, ver: 0x1)
>scan_chain
TapName Enabled IdCode Expected IrLen IrCap IrMask
-- ------------------- -------- ---------- ---------- ----- ----- ------
0 auto0.tap Y 0x10147043 0x00000000 2 0x01 0x03
>
July 17th, 2015, 12:32
July 17th, 2015, 12:35
GeorgeKJones62 wrote:Use "dump_image 0.bin 0x0 0x10000" and "dump_image FFFF0000.bin 0xFFFF0000 0x10000" and start looking at the code to see other areas to dump. And post the files too since now I'm curious
- George
July 17th, 2015, 20:14
July 17th, 2015, 22:32
July 20th, 2015, 9:34
HaQue wrote:Thanks George, I will give that a try.
I am looking at buying a better JTAG adapter first, I don't think this BP is up to any serious JTAGging
July 20th, 2015, 9:37
HaQue wrote:tried it.
I don't seem to have the command "dump_image" available?
cant see it in help. I am using Open OCD 0.9.0-rc1-dev-00001
January 17th, 2018, 4:35
January 17th, 2018, 9:42
January 17th, 2018, 16:40
January 19th, 2018, 3:31
January 19th, 2018, 15:33
blackwolf511 wrote:A fastest thing, to see if it is the chip or not, it would be
to check the SMD resistors and the SMD capacitors for some short circuit.
January 21st, 2018, 9:38
Powered by phpBB © phpBB Group.