I found having only one monolith wire adapter per reader is a pain. I created some PCBs and was about to brag how pretty they are, until I found why there are revisions.. missed a dang trace!
This was a test to get familiar with PCB design software again. Now I am comfortable I am starting on adapters for Rusolut if I get permission from the geniuses over yonder.
I really wanted to go with sockets, but this year has been very tough financially with a couple of disasters, and I cannot afford to produce them. So I am looking at a range of wire adapters for different chips where the wire points are in good locations for the position of a chips signal.
Also looking at wire adapter + jumper array so we wire up some of these ridiculous BGAs and can change jumpers for different LUNs, but will see how all this goes.
Mistake 1: