All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Atola Imager screws falling out
PostPosted: September 2nd, 2010, 16:29 
Offline

Joined: February 15th, 2006, 3:38
Posts: 1090
Location: canada
ok not had much use but i heard something rattling inside my unit

out pops the following


2 washers

1 bolt

1 screw

the screw fell of the fan

lucky i did not plug the unit in or something bad might have happen.

i notice that the screws are not tight at all on the unit
you should check your screws around the fan.
and you want to check your fan screws

quality control needs to be worked on


as for putting these screws back in the unit
i have to open it up
but i dont want to as i still got a warranty left


Top
 Profile  
 
 Post subject: Re: Atola Imager screws falling out
PostPosted: September 2nd, 2010, 23:15 
Offline
User avatar

Joined: September 8th, 2009, 18:21
Posts: 11544
Location: Australia
craig6928 wrote:
ok not had much use but i heard something rattling inside my unit

out pops the following


2 washers

1 bolt

1 screw

the screw fell of the fan

Made in China? ;-)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group