ST3000DM001

[jonbang]

Anything to do here? It spins up, click twice and spins down It gets ID, firmware etc, but says the size is 3,86gb. Is this dead or is there something i can do?

Attachments

[mhp666]

Hi.
I think it is a lost case.
Every time the needles pass through that area I think they will break.
Also if I'm not mistaken, the other surfaces of the HDD have the same scratch.

A greeting.

[MindMergepk]

most likely gone, if customer is willing, partial recovery can be attempted...

[pcimage]

most likely gone, if customer is willing, partial recovery can be attempted...

Yes, maybe possible for partial but requires thorough investigation...

Not cheap

[jonbang]

most likely gone, if customer is willing, partial recovery can be attempted...

Ok, do you know how to partially recover? I have both mrt and pc3k available.

[digisupport]

most likely gone, if customer is willing, partial recovery can be attempted...

Ok, do you know how to partially recover? I have both mrt and pc3k available.

In your case I would remove top head, do the necessary ROM modifications to get the drive to start without h5

[pcimage]

most likely gone, if customer is willing, partial recovery can be attempted...

Ok, do you know how to partially recover? I have both mrt and pc3k available.

In your case I would remove top head, do the necessary ROM modifications to get the drive to start without h5

After checking all heads for debris under the microscope of course!

But in any case, it’s a cleanroom job.

[digisupport]

most likely gone, if customer is willing, partial recovery can be attempted...

Ok, do you know how to partially recover? I have both mrt and pc3k available.

In your case I would remove top head, do the necessary ROM modifications to get the drive to start without h5

After checking all heads for debris under the microscope of course!

But in any case, it’s a cleanroom job.

I take so many things for granted, thank you for completing my answer pcimage