Failed to recognize in bootcode.
It shows wrong characters. In normal f3 normal mode it detects it well.
2 clicks and the mortor stops.
It is a case study, no matter the data.
| Attachments: |
|
screen.jpg [ 278.4 KiB | Viewed 8108 times ] |
| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| ST500LT012 TERMINAL FAIL http://forum.hddguru.com/viewtopic.php?f=28&t=37449 |
Page 1 of 1 |
| Author: | mhp666 [ September 27th, 2018, 12:45 ] | ||
| Post subject: | ST500LT012 TERMINAL FAIL | ||
Failed to recognize in bootcode. It shows wrong characters. In normal f3 normal mode it detects it well. 2 clicks and the mortor stops. It is a case study, no matter the data.
|
|||
| Author: | mhp666 [ September 30th, 2018, 17:50 ] |
| Post subject: | Re: ST500LT012 TERMINAL FAIL |
It is a broken unit. It does 2 clicks and it stops in 1 second ~. If I do not connect it to the mrtlab, it does not detect it and the engine stops immediately. Once I stopped the engine if I detected it with mrtlab I detected it as SEAGATE and then as generic. I'm going to select it as a thin laptop and it has short-circuited the ROM and if I read it I upload it. Thank you. |
|
| Author: | mhp666 [ October 2nd, 2018, 9:57 ] |
| Post subject: | Re: ST500LT012 TERMINAL FAIL |
When I get another one like this, I will study it carefully, and I will put the results we find. Thanks for your interest. |
|
| Author: | mhp666 [ October 2nd, 2018, 14:36 ] |
| Post subject: | Re: ST500LT012 TERMINAL FAIL |
By isolating the PCB and selecting the Yarax family 86 HDD model instead of the one detected by the MRTLAB (Yarrar_5400), the terminal works correctly. It gives me the wrong head type failure, but it is normal the PCB is isolated. I assume they are the heads that are wrong. I have visualized CAP, SAP and RAP and they seem to be correct. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|