HDD GURU FORUMS http://forum.hddguru.com/ |
|
firmware needed for maxtor diamondmax plus 9 80 gb pata http://forum.hddguru.com/viewtopic.php?f=28&t=37456 |
Page 1 of 1 |
Author: | magnetepazzo [ September 28th, 2018, 10:34 ] |
Post subject: | firmware needed for maxtor diamondmax plus 9 80 gb pata |
Hi guys, I need firmware for pata hdd 80 gb calypso III Maxtor diamondmax plus 9 for MRT, thanks to all |
Author: | mrtpro [ September 29th, 2018, 22:49 ] |
Post subject: | Re: firmware needed for maxtor diamondmax plus 9 80 gb pata |
magnetepazzo wrote: Hi guys, I need firmware for pata hdd 80 gb calypso III Maxtor diamondmax plus 9 for MRT, thanks to all Hello, sir! I have asked our tech support to help search FW resource. However, considering that disk is very old ,it is hard to seek one. Also you can search FW on other forum. your FW version is 41BW0 and Y3 . 3 is for 3 heads. |
Author: | magnetepazzo [ October 1st, 2018, 10:33 ] |
Post subject: | Re: firmware needed for maxtor diamondmax plus 9 80 gb pata |
Spildit wrote: The big question now ... If this post is the same drive as the other post - viewtopic.php?t=37390 it does look like the OP did already swap heads on the drive so ... WHY THE HELL didn't he backup the firmware of the donnor drive first ? If the drive is compatible enough for the heads to work on the damaged drive i would say that the first thing to do would be to backup the working drive firmware for later use ? you're running too much, I have two identical units with two different problems so I did two different posts. It seemed simple to understand However, I thank you for the answer, mrt knows my problem because I had already talked to one of their technicians that's why he gave me that information. As far as backing up the other post you were talking about I have a different problem, of course I opened the unit safely and replaced the heads but the problem remains the same, irregular clicks. Unfortunately, this unit was subjected to a severe electric shock and some components exploded, I replaced the pcb and I recovered the ardent chip replacing it on the new pcb I had but the problem remains, so I thought it was a head problem and I proceeded to replace it, but nothing. The unit was identical to the one in question but was slightly more recent. Thanks again for your precious directions |
Author: | michael chiklis [ October 5th, 2018, 19:37 ] |
Post subject: | Re: firmware needed for maxtor diamondmax plus 9 80 gb pata |
You can search for PC3000 fw, they are compatible with mrt. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |