HDD GURU FORUMS
http://forum.hddguru.com/

ST3000DM001
http://forum.hddguru.com/viewtopic.php?f=28&t=38768
Page 1 of 1

Author:  jonbang [ August 17th, 2019, 17:35 ]
Post subject:  ST3000DM001

Anything to do here? It spins up, click twice and spins down It gets ID, firmware etc, but says the size is 3,86gb. Is this dead or is there something i can do?

Attachments:
sgt surface.jpg
sgt surface.jpg [ 186.06 KiB | Viewed 11316 times ]

Author:  mhp666 [ August 17th, 2019, 18:06 ]
Post subject:  Re: ST3000DM001

Hi.
I think it is a lost case.
Every time the needles pass through that area I think they will break.
Also if I'm not mistaken, the other surfaces of the HDD have the same scratch.

A greeting.

Author:  MindMergepk [ August 18th, 2019, 5:29 ]
Post subject:  Re: ST3000DM001

most likely gone, if customer is willing, partial recovery can be attempted...

Author:  pcimage [ August 18th, 2019, 8:00 ]
Post subject:  Re: ST3000DM001

MindMergepk wrote:
most likely gone, if customer is willing, partial recovery can be attempted...


Yes, maybe possible for partial but requires thorough investigation...

Not cheap :-(

Author:  jonbang [ August 18th, 2019, 12:54 ]
Post subject:  Re: ST3000DM001

MindMergepk wrote:
most likely gone, if customer is willing, partial recovery can be attempted...


Ok, do you know how to partially recover? I have both mrt and pc3k available.

Author:  digisupport [ August 18th, 2019, 12:59 ]
Post subject:  Re: ST3000DM001

jonbang wrote:
MindMergepk wrote:
most likely gone, if customer is willing, partial recovery can be attempted...


Ok, do you know how to partially recover? I have both mrt and pc3k available.


In your case I would remove top head, do the necessary ROM modifications to get the drive to start without h5

Author:  pcimage [ August 18th, 2019, 13:01 ]
Post subject:  Re: ST3000DM001

digisupport wrote:
jonbang wrote:
MindMergepk wrote:
most likely gone, if customer is willing, partial recovery can be attempted...


Ok, do you know how to partially recover? I have both mrt and pc3k available.


In your case I would remove top head, do the necessary ROM modifications to get the drive to start without h5


After checking all heads for debris under the microscope of course! :-)

But in any case, it’s a cleanroom job.

Author:  digisupport [ August 19th, 2019, 0:01 ]
Post subject:  Re: ST3000DM001

pcimage wrote:
digisupport wrote:
jonbang wrote:
MindMergepk wrote:
most likely gone, if customer is willing, partial recovery can be attempted...


Ok, do you know how to partially recover? I have both mrt and pc3k available.


In your case I would remove top head, do the necessary ROM modifications to get the drive to start without h5


After checking all heads for debris under the microscope of course! :-)

But in any case, it’s a cleanroom job.


I take so many things for granted, thank you for completing my answer pcimage :)

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/