Seagate Barracuda 7200.12 stopped working
Hi guys,
Sorry for my bad English!
I have a Seagate Barracuda HDD with the following specifications:
Family: 7200.12
Model: ST3250318AS
Size: 250Gbytes
P/N: 9SL131-300
Firmware: CC44
When I looked in the BIOS model, saw that my Seagate HDD was recognized as 0MB and 0LBA!!
I have tried with china PC 3000; with dku5
but failed
someone please help me?
I use this command with Dku5 , but without success
What is the command line for CC44 7200.12 ?seagate wrote:
to 7200.11, but 7200.12 ?
On Terminal press CTRL + Z:
F3 T>
F3 T> / 2
F3 2> Z
Spin down complete
Time elapsed msecs 0.147
F3 2>
Wait 5sec and remove the paper separating the Moto phone. Now screw just enough to make a link between PCB and hda (just be calm, relax!).
Then, press CTRL + Z again:
F3 2> U
Spin up Complete
Time elapsed 7.457 seconds (if you get this msg you used good until everything here)
F3 2> / 1
F3 1> N1
F3 1> / T
F3 T> <<<At this step you need to pull cable sata POWER OFF, wait 10sec HDD signal, and then back to POWER. (Not the PCB!).
When done, press CTRL + Z.
F3 T>
F3 T> I4, 1.22
F3 T>
F3 T> M0, 2.2 ,,,,, 22 <<<This command takes a little over a minute to complete!
WR max retries = 00, Max Rd retries = 00, T-Max ECC Level = 14, Max retries = 00C8 certification Rewrite
User format partitions 5% complete, Area 00, Pass 00, LBA 00004339, 00000080 ErrCode, Time elapsed 05 seconds 0 minutes
Users successfully format the partition - 0 minutes 05 seconds time elapsed
F3 T>
someone please help me?