All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 24 posts ]  Go to page Previous  1, 2
Author Message
 Post subject: Re: Introduction of MRT software version 2127
PostPosted: September 28th, 2018, 11:21 
Offline

Joined: February 1st, 2016, 19:51
Posts: 129
Location: Cyprus
saltwater wrote:
Hi!
When MRT failed to load the drive SA module dir, and using default module dir, close utility, and open it again.
Sometimes the MRT utility does not get enough time for the drive to gain access to SA module list (FIT), and the utility jumps out this important step, and uses "default module list".

It makes sense but it's not the case yesterday I power on the drive and mrt immediately load the drive SA module dir, after a while I power on again but now even after four times I close utility and open it again mrt still failed to load the drive SA module dir only in the fifth time it did, but it's not a big deal the real problem of can't read rom and can't edit head map is remain although I hope it will be fix in the new update 2128 mrt upload few days after the current but it still does not work.


Top
 Profile  
 
 Post subject: Re: Introduction of MRT software version 2127
PostPosted: October 3rd, 2018, 13:29 
Offline

Joined: February 1st, 2016, 19:51
Posts: 129
Location: Cyprus
Spildit wrote:
For some reason many tools like MRT and SeDiv do apear to have problem with this and are not able to properly work with majority of "modern" drives to read/write ROM by terminal. SHTR works fine with those ...

Can you edit head map in ram in common samsung 2.5" with SHTR ?


Top
 Profile  
 
 Post subject: Re: Introduction of MRT software version 2127
PostPosted: October 3rd, 2018, 17:39 
Offline

Joined: February 1st, 2016, 19:51
Posts: 129
Location: Cyprus
Spildit wrote:
If the goal is to clone/image by heads you can use SHT/SHTR to read the zone table :

The goal is in case of scratches on platters it's better first disable head in ram then do head map in cloning tool and hot swap involved here also.


Top
 Profile  
 
 Post subject: Re: Introduction of MRT software version 2127
PostPosted: October 3rd, 2018, 17:40 
Offline

Joined: February 1st, 2016, 19:51
Posts: 129
Location: Cyprus
Spildit wrote:
If the goal is to clone/image by heads you can use SHT/SHTR to read the zone table :

It's good ideas but my goal is in case of scratches on platters it's better first disable head in ram then do head map in cloning tool and hot swap involved here also.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 24 posts ]  Go to page Previous  1, 2

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 13 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group