Lenovo FW has additional protection, I don't think free tools would serve much help

You might need to get "normal" main ROM code and move all CPs from your ROM to the "unlocked" ROM if special "Lenovo" ROM main code is preventing the use of VSCs. Then you need to send the VSC to regen the "S" sector on platter or as alternative read/write that sector by PBA...

No free sollution. Most likely there will never be a free sollution for this unless the VSC that is used to regen "S" somehow does work on your drive even with "Lenovo" firmware ....

Lenovo FW has additional protection, I don't think free tools would serve much help

You do need to read ROM with extrenal programmer, carve the CPs and write those to ROM with normal main code, then you can use VSC to re-create "S" or read/write "S" by VSC ...

Maybe you should PM him the VSCs to unlock the drive ?

You say this?
It's a 1-minute job. SON + VSC...

AFAIR (was 5 years ago) SON is locked on those

I don't have any problem with that !!!

Just post the sollution here if you want to !!!

Ok,
i got some news, i have found the bios dump of the lenovo where this hdd is from.
The password from the laptop is on this dump (see picture) 2 same lines with encrypted password, i'm 99% sure this password is also the hdd password.
can i use this with victoria?

Password Characters and Data

• Supported characters
– Alphabet (case insensitive)
– Number
– Space ‘ ‘

• Code set
– Scan code

• Maximum length
– 64 characters

• Data transformation
– Hash 64 scan codes by SHA-256 and take first 16 bytes

Power On Password

• Storage
–Inside HDD
–Security feature is locked by SET FREEZELOCK command

• before exiting POST

• when the _GTF is evaluated by a storage driver at resuming from S3

• Salting
–Salted with the hashed Model number and the serial number before sending to HDDs

• Master HDP and User HDP are supported

Supervisor Password

• Requested to input when:
– BIOS Setup is invoked
– Signature diskette is detected
– EFI Shell is invoked
– BIOS update is invoked while OS is running
– TPM state change is invoked while OS is running

• Storage
– EEPROM Block 6 (C2 Space)
10-1Fh: Primary SVP
20-2Fh: Backup SVP

• Salting
– Salted with the random number in the boot block before storing in the EEPROM

Hard Drive Password

• Storage
– Inside HDD
– Security feature is locked by SET FREEZELOCK command

• before exiting POST

• when the _GTF is evaluated by a storage driver at resuming from S3

• Salting
– Salted with the hashed Model number and the serial number before sending to HDDs

Power On Password

• Requested to input at:
– Boot
– Waking up from Hibernate (POST)

• Storage
– CMOS

Lower 38-3Fh: First 8bytes of hashed passphrase (Offset 0-7h)
Upper 38-3Bh: Remaining 4bytes of hashed passphrase (Offset 8-Bh)
Upper 3Ch : Checksum of lower 38-3Fh and upper 38-3Bh

– Storage are locked

• before exiting POST if the signature diskette is not detected

• before jumping to OS waking vector

• Salting
– Salted with the random number in the boot block before storing in the CMOS

i have found the bios dump of the lenovo where this hdd is from.

If you have the original laptop, does this mean that the [unhashed] HDD password is known and that you are needing to circumvent the password because the laptop is dead? If so, have you tried the HDD in another Lenovo laptop?