I am trying to get the corresponding ROM chip, but I can not peel off with Hot Air Pencil or soldering iron that I have now.
Everybody solder, How are you peeling off?

Thanks Nick for sharing compatible PCB info.
today i have all data saved. i Have moved the rom-chip 602 to donor PCB

Frank

So, i have one of USB MQ01UBD100, and found donor PCB SATA PCB from the MQ01ABD100. Do i still need to swap BIOS? Or can i it simply work by switching PCB?

Must

_________________
A Recovery Service In Turkey . Veri Kurtarma Türkiye https://www.digitalverikurtarma.com
Donor Drives hdddonormarket.com

Hi, everyone,

I have a couple questions about this specific drive and if you think a new board would help.

Out of nowhere the drive just stopped working. It was fine one day, and the next it is just dead. The drive doesn't light up when I connect it to a computer, no sounds, OS doesn't recognize it. I tried different cables and different computers.

I was hoping that the interface is just bad and the drive is OK. I just had to do a data restore on a seagate drive and it cost $700. I really don't want to have to do it again.

Do you think this sounds like a bad board? I tried to remove it to make sure everyone was connected, but one of the screws is stripped and couldn't get the all off. Any tips on dealing with a stripped screw when they are so small?


Thanks for any help;

There are two fuses near the USB port.

_________________
A backup a day keeps DR away.

Thanks for reply. I'm taking from that that you think one or both of the fuses might have blown?

Are they the two yellowish looking pieces that I have boxed out in green on the attached image?

Do they just pop out to replace? They look like they were soldered in.

Thanks again

Here they are:

_________________
A backup a day keeps DR away.