Hello!

Terminal output :
Interface task reset
4096k x 16 buffer detected
TONKA - 1_Disk M-27 03-30-05 11:42
Head Mask FFFF - Switch to full int.
Spin Ready
3.06 10-07-05 15:20
(P)PATA Reset
Failed sys sect. write

Read Ver Retrys

Read Ver Retrys

Read Ver Retrys

Read Ver Retrys

Read Ver Failure!
Failed sys sect. write
Master
Failed sys sect. write

The drive take a while ( approx. 30 sec ) to get ready
But after ready no initialization.

Any ideas ?

Thanks in advance.

What has Ctrl+x to say ?

Said :

T> AT NIWOT Seg
dT(ms) Cmd Cnt LBA | LBA Cmd Cyl Hd Sct Cnt Start Sz Ofs
9999999 ff ffff ffffffff | 00015aa1 56 00015aa1.0.002 0001 3fc0 0001 0000
0 ff ffff ffffffff | 00015aa1 58 00015aa1.0.002 0001 3fc0 0001 0000
0 ff ffff ffffffff | 00015aa1 56 00015aa1.0.002 0001 3fc0 0001 0000
0 ff ffff ffffffff | 00015aa1 58 00015aa1.0.002 0001 3fc0 0001 0000
0 ff ffff ffffffff | 00000000 aa 00000000.0.036 0000 0002 0005 0001
0 ff ffff ffffffff | 00015aa1 58 00015aa1.0.011 0001 3fc0 0001 0000
0 ff ffff ffffffff | 00015aa1 58 00015aa1.0.006 0001 3fc0 0001 0000
0 ff ffff ffffffff | 00015aa1 58 00015aa1.0.002 0001 3fc0 0001 0000
0 ff ffff ffffffff | 000f0019 6c 000f0019.4.118 0400 0000 0001 0000
0 ff ffff ffffffff | 000f0000 36 000f0000.4.118 0400 0000 0001 0000
0 ff ffff ffffffff | 00015aa3 58 00015aa3.0.20c 0001 3fc0 0001 0000
0 ff ffff ffffffff | 000f0000 36 000f0000.4.118 0400 0000 0001 0000
0 ff ffff ffffffff | 0000460b 4a 0000460b.0.397 ffff 0000 0415 0073
0 ff ffff ffffffff | 0000460b 02 0000460b.0.000 0000 f6d6 00c5 460b
17385 00 0242 00000000 | 0000460b ff 0000460b.7.8e9 000d 0000 0000 0000