WD1200BEVS Not accessible

[MANDR]

I have a WD1200BEVS-00UST0 which reaches ready and has capacity of 0. When entering PC3000 utlity I get the following error:

Techno mode key
Techno mode key......................... : Ok

RAM:
Zone allocation table................... : HDDs RAM reading error Techno CMD sending error Device Error Detected: "VSCE PERM OVL NOT LOADED"
SA SPT.................................. : SA SPT determination error Techno CMD sending error Device Error Detected: "DISK DAM ERROR"

Head number reading..................... : Ok
Heads number............................ : 2

ROM:
ROM reading............................. : Ok
ROM Data size........................... : 192 Kb
Head Map Reading Error.................. : Head map check sum error
ROM version............................. : 06.19C
ROM generation.......................... : 06.19C
Link table version...................... : 01.2E.
Heads configuration..................... : default
Head map................................ : 0,1

Service area:
SA dir reading.......................... : SA Directory checksum error
Configuration reading................... : Module 02 not found


Any ideas?

Thanks

[BlackST]

Check for rom corruption. The fact the headmap has checksum error is suspect.

[BlackST]

P.s. Did you try another pcb and checked ALSO the translator?

[papaisho]

Any luck with the error as per solution.

I'm getting the Head Map Reading Error : Head map sum error on WD750BPVT

Regards,