Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
January 14th, 2009, 1:26
Hi guys
I have 2 WD Green Power WD10EACS suffer from the same problem, the drive spin up and then no clicking and then spin down after few seconds. As if there isnt enough power. The drives have not been dropped in anyway.
Anyone come across this problem?
Thank's
January 14th, 2009, 2:51
Are you sure there is no head moves at all?
These drives not too noisy...
if you have right, this can be pcb or preamp issue.
Regards,
Janos
January 14th, 2009, 6:26
the motor is trying to spin up to speed but then power off, no stickion on HDA. Could this be the motor controller chip malfunction?
January 14th, 2009, 6:49
TerraNova wrote:the motor is trying to spin up to speed but then power off, no stickion on HDA. Could this be the motor controller chip malfunction?
yes, it could be, but only one VCD chip responsible for both 2 motors!
Much more likely it is preamp / VC / pcb's other parts problem, i think...
Did you measured the VC?
I have seen some really strange problems before.....
Regards,
Janos
January 14th, 2009, 23:08
Update: Data Successfully recovered, it's the preamp that playing up. Thanks NC
January 15th, 2009, 7:50
TerraNova wrote:Update: Data Successfully recovered, it's the preamp that playing up. Thanks NC

Nothing...
Powered by phpBB © phpBB Group.