Switch to full style
Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
Post a reply

HDD Spins but not found in BIOS

March 4th, 2009, 17:09

Ok guys so I was running a badly needed defrag on an old laptop hdd and a few minutes after it completed (I let it just sit there afterwards) the screen went black and the machine was frozen. I powered down and when I turned the laptop back on I received the cannot find disk 0 error. I checked in the BIOS but the drive is not recognized there either. So I took the drive out and hooked it up to a desktop I have with an adapter. I can hear and feel it spinning, no clicking or weird noises, but the BIOS in this PC does not see the drive either. I am trying to locate another drive so I can switch out the logic board but I was wondering if there was anything else I could try first. Thanks!

Re: HDD Spins but not found in BIOS

March 4th, 2009, 17:32

Even if you didn't specify, sounds like a travelstar hdd... Changing the pcb is not a good idea.

Re: HDD Spins but not found in BIOS

March 4th, 2009, 17:46

Why does everyone assume its the pcb?

Re: HDD Spins but not found in BIOS

March 4th, 2009, 18:29

thatdellguy wrote:Why does everyone assume its the pcb?

Oh if it was so simple :lol:
What I would give if all the problems could be fixed just by
swapping pcb's.

Re: HDD Spins but not found in BIOS

March 4th, 2009, 18:42

Yah at least try the freezer or double boiling first before assuming the pcb... :yayaya:

Re: HDD Spins but not found in BIOS

March 4th, 2009, 18:48

thatdellguy wrote:Yah at least try the freezer or double boiling first before assuming the pcb... :yayaya:

ROTFLMAO

Re: HDD Spins but not found in BIOS

March 4th, 2009, 22:53

You forgot the toaster oven.

Re: HDD Spins but not found in BIOS

March 5th, 2009, 11:59

Unless the drive is an older model IBM or Hitachi (pre-IBM) then changing the PCB will be of no value because there are flash ROM contents that have to be transferred as well. Frankly when faced with a spinning drive the PCB is not the most likely culprit.
Post a reply