Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
March 14th, 2009, 17:55
Hi,
I need an advise...
What do I need to match in the donor?
P/N:
HDA P/N:
CONFIG CODE:
FIRMWARE:
DATE CODE:
SITE CODE:
Thank you in advance!!!
March 14th, 2009, 20:09
If heads, usually site code, P/N, and HDA P/N are sufficient with this series.
If PCB, site code, firmware, and number on the white PCB sticker are enough.
March 14th, 2009, 22:03
Thanks, I'm still new in this business.
How about the Site Code? I have a donor drive that everything matching except the Site Code.
WHen I tried the different firmware and P/N and HDA P/N, the head didn't work. It stopped clicking but spins up for a few seconds but the motor goes off and the drive won't get detected by the BIOS.
March 14th, 2009, 22:46
In my limited experience, Site Code is perhaps the most important factor.
March 19th, 2009, 2:43
How about if F/w is 3.54, 3.76 , 8,54 and 8.76
if you know what this f/w mean... finding a head compatibility is not so difficult..
Powered by phpBB © phpBB Group.