Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
June 17th, 2009, 12:04
I have tried every thing I know to recover data from any WD black top hdd, same problem every time - 3 hard clicks then the drive spins down.
I have tried:
heads swaps
firmware swaps
pcb swaps
spin I/C swaps
pulling out the platters and putting them in to a new matching drive case and using the original parts and also the new parts(matching #'s of course)
swapping the pre-amps
Any one got any ideas or info???
June 17th, 2009, 22:07
Yes. Wrong initial diagnose/method, and eventually you have to deal with alignment - which is anyway a PITA for everyone...
June 18th, 2009, 9:24
idrdata wich was u patient fully model , dcm etc, and wich was u donnor model ?
Regards
Powered by phpBB © phpBB Group.