How to deal the 1.5TB with firmwire CC1H 7200.11?

[Amigo]

Barracuda 7200.11
Modle:ST31500341AS
Firmware: CC1H

Now the harddisk cannot be recoginized in the Bios.
After power on,it give out low noise something like unable to spin up.
So,I want to connect it to RS232 terminal in the way :
http://www.msfn.org/board/solution-seag ... l__7200.11

But the terminal has no response no matter I press "Ctrl+T" nor any other Keys.
(It shows "F3 T>" when the HDD is replaced by 500GB or 1TB 7200.12)

[rameez]

check baud rate .

[vhg]

Use 38400 8 None 1 None

I am in the same boat with you except i can still see my drive but it has SMART errors, I am trying to recover my data too...

[HDD Spaz]

Terminal is not going to fix your seized motor.

[BlackST]

At least not yet.

[DataWreck]

You should be able to confirm if the motor is seized as the terminal will output.

"Buzz Buzz Buzz"

Over and over as the motor tries to start.

Leigh

[hddguy]

You should be able to confirm if the motor is seized as the terminal will output.

"Buzz Buzz Buzz"

Over and over as the motor tries to start.

Leigh

Not on this disk. This is F3 series.

[DataWreck]

Fair point, your right. Have been at older ones all afteroon

[datasolution]

rameez, hi rameez
salm val e kum
i am sachin vora we had talk before years n i would like to talk again if can i want some suggestions