Get Data Back NTFS produces a blank result

Data recovery and HDD repair discussions

Switch to full style
Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
Post a reply
ontariotech
  • ontariotech
  • Posts: 88
  • Joined: March 8th, 2009, 15:41
  • Location: Hiding Between the Platters

Get Data Back NTFS produces a blank result

January 22nd, 2011, 17:34

Dealing with a WD 2TB drive here.

Get Data Back scans it normally with no errors whatsoever ....

Then at the final "show results" stage the whole recovery table comes up as blank?
pcimage
  • pcimage
  • Posts: 7864
  • Joined: November 29th, 2006, 10:08
  • Location: UK
  • Website

Re: Get Data Back NTFS produces a blank result

January 22nd, 2011, 17:42

Either it's not NTFS (e.g. FAT, Linux, XFS, ZFS........) or it's encrypted (e.g. from certain WD enclosures)
fzabkar
  • fzabkar
  • Posts: 16960
  • Joined: September 8th, 2009, 18:21
  • Location: Australia
  • Website

Re: Get Data Back NTFS produces a blank result

January 22nd, 2011, 18:51

Could we see the partition table and boot sector with Microsoft's Sector Inspector?
http://www.users.on.net/~fzabkar/SecInspect.zip

Extract the above archive to the one folder and execute the SIrun.bat file. The procedure will generate a report file named SIout.txt.
Post a reply
Switch to full style

Powered by phpBB © phpBB Group.

Board index