Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
November 15th, 2011, 20:25
Wanted some feedback on the CPR headcombs for use on a WD1200BB. I believe the headcomb for this model is PC06. There is a ridge on the inside of the drive case that makes removing head 0 with the HDRC combs nearly impossible. Essentially the design of the HDRC tool pushes head 0 down too much and it comes into contact with the ridge on the case. Does the CPR headcomb have a similar problem? There is very little clearance available, so wanted to know if others had a hard time with replacing heads on these drives.
November 16th, 2011, 7:56
anything on the compatibility list ?
they are pretty good on the email, you could ask them as its an older drive
Andy
November 20th, 2011, 19:29
sknopp wrote:Wanted some feedback on the CPR headcombs for use on a WD1200BB. I believe the headcomb for this model is PC06. There is a ridge on the inside of the drive case that makes removing head 0 with the HDRC combs nearly impossible. Essentially the design of the HDRC tool pushes head 0 down too much and it comes into contact with the ridge on the case. Does the CPR headcomb have a similar problem? There is very little clearance available, so wanted to know if others had a hard time with replacing heads on these drives.
I do not think anybody on this forum had luck with HDRC
Powered by phpBB © phpBB Group.