Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
May 8th, 2012, 23:10
After Connecting the HDD - STATUS comes READY.
While LOAD FROM HDD - Everything loads fine Except HEAD COUNT (it shows - 6) Under Low Speed Access But Status "ERROR"
Then FW Defect Scan (It's ACCESSIBLE) - Stops after scanning few F/W - Then Scan Again, in repeat - It completes without any DEFETCS. All r FINE.
Made a SMART RESET.
In Defects List Management - VIEW DEFECTS LIST - doesn't come with First try, in 2nd try Shows Everything...
Translator Regeneration was also made.
The drive has SLOW ACCESS - in every 900000 to 1000000 sectors it starts to see BAD(ERRORS)
Checked different area randomly, it's happening where ever I tested.
Is it happening due to Poor HEAD?
May 9th, 2012, 20:54
Original raw SMART values?
May 10th, 2012, 4:00
Didn't keep the original SMART value. But it was FINE.
Powered by phpBB © phpBB Group.