Seagate ST9500325AS

[pclab]

Hi

This HDD has the same behaviour than the BSY bug.

After connected to terminal, It goes Ready, Can get >T, but when I Issue any command I get the LED error.
Checked heads, as this HDD was on a external enclosure, and they seem fine and no scratches.
I think that only Ace could already solve this, for what I have searched. Is this right?
Is there any other ideas to solve this?
Thanks

[BlackST]

Is it the one we were talking about ?

[pclab]

No, it's another victim.

[BlackST]

OK I'll be online later

[pclab]

The Log:


Rst 0x08M

RW cmd 002F req = 18 F0 9F E5 18 F0 9F E5 18 F0 9F E5 18 F0 9F E5 18 F0 9F E5 00 00 A0 E1

opts = 00000000


RW Err = 84150180

ASCII Diag mode

F3 T>V4


LED:000000CC FAddr:0025B3FF

LED:000000CC FAddr:0025B3FFÀ
Rst 0x08M

RW cmd 002F req = 18 F0 9F E5 18 F0 9F E5 18 F0 9F E5 18 F0 9F E5 18 F0 9F E5 00 00 A0 E1

opts = 00000000


RW Err = 84150180


ASCII Diag mode

F3 T>
Wyatt TetonST4 Mule 01 Teton4.2 DDR160M 240M 248SS ZG
Product FamilyId: 3C, MemberId: 01
HDA SN: 5VELP7TW, RPM: 5449, Wedges: F8, Heads: 4, Lbas: 3A386030, PreampType: 5A 14
PCBA SN: 0000N2056T10, Controller: TETONST_4(63A2)(3-0E-4-2), Channel: AGERE_COPPERHEAD_LITE, PowerAsic: MCKINLEY MOBILE PLUS Rev 15, BufferBytes: 800000
Package Version: WY05A7.BSM1.DA99LN., Package P/N: ---------, Package Builder ID: 84,
Package Build Date: 05/13/2011, Package Build Time: 18:53:29, Package CFW Version: WY05.BSM1.00357331.8400,
Package SFW1 Version: 7AEE, Package SFW2 Version: ----, Package SFW3 Version: ----, Package SFW4 Version: ----
Controller FW Rev: 00990001, CustomerRel: 0002, Changelist: 00357331, ProdType: WY05.BSM1, Date: 05/13/2011, Time: 185329, UserId: 00080603
Servo FW Rev: 7DED
RAP FW Implementation Key: 0E, Format Rev: 3D03, Contents Rev: 26 1E 04 05
Features:
- Quadradic Equation AFH enabled
- VBAR with adjustable zone boundaries enabled
- Volume Based Sparing enabled
- IOEDC enabled
- IOECC enabled
- DERP Read Retries enabled
- LTTC-UDR2 compiled off
ASCII Diag mode

F3 T>