HI all,
I have a very unusual problem.
I have recently aquired a WD drive, the details are..
WD2500JD -00HBB0
BIOS 82H
FIRMWARE 08.02D08
DCM HSBACTJAA
WD CAVIAR SE/SE16 SATA 1
I regularly use MHDD to clrmbr, nhpa and either fasterase (internal secure wipe) or erase.
I do this for all the drives I work with to start from a clean slate.
I have worked on close to 80 drives in the last year and I have never come across this before.
When I attempt to action an "clrmbr" command, the usual warning confirm pops up... are you sure yo want to clear the mounted boot record etc.. accept in this case the the word "VIRUS" (just like that in uppercase) pops up partially writing over the firmware revision code, waiting for a Y/N confrim to action the clrmbr command.
Pressing Y completes the clrmbr command without error and the correct firmware code is then displayed i.e 08.02D08
Also HD Sentinal reports the ATA checksum as being "INVALID"
Please view the video and photo's I have made and stored in my windows skydrive public folder. This will show you in real terms what the issue is.
The link is...
https://skydrive.live.com/redir?resid=5 ... der%2c.pngI am experiencing some serious (equpment damaging) stabilty issues randomly, these appear to be volatge related but this has been going on since beofre I owned the drive.
The drive is 100% healthy and has 100% performance. For a ten year old drive it has only has an uptime of 240 days, which is extremely low.
Also there is no clicking, scrapig, dragging or any type of untoward noise coming from the drive which would indicate a fault.
I have worked with many drives that have bad sectors or data transfer problems and this drive does not display any similar symtoms. i.e delayed boot, slow data transfer, abnormal noises, fail to boot, windows freeze etc etc etc
The other thing which seems relevant is that I don't believe MHDD has virus detection capabilities, perhaps some one could confirm that belief.
So how on earth is MHDD throwing that up.
I'm guesing that some one has intentionally managed to access the firmware, replaced the firmare code some where in the hex to the word VIRUS and then reflashed the hdd. That would explain why the ATA checksum - primarily drive lable information - comes up invalid.
The odd thing about that is, it's illogical to blatantly advertise any virus if your objective is to infect a system...
I have a hunch that this change was done to get a reaction as opposed to thier actually being any virus present in the firmware.
I have also scanned the drive with Kaspersky Rescue Disc 10, and it's no surprise that no virus has been detected.
Any ideas or precidents here would be appreciated.