Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
March 14th, 2014, 2:44
Model ST9500423AS-9R143-020
Fw: 0003HPM1
Drive spins up initializes perfectly as if going to be READY but remains BUSY
Tried to get terminal access even by shorting the read Channel but could get it only for fraction of seconds then it gives
LED CC Error
Following is the TERMINAL Output
EarlySpinup Enabled
Rst 0x10M
ASCII Diag mode
F3 T>
LED:00000067 FAddr:00384F74
LED:00000067 FAddr:00384F74
LED:00000067 FAddr:00384F74
Any suggestions please ???
Powered by phpBB © phpBB Group.