command barcudda 7200.7

[galaxy]

Need command for barcudda 7200.7

[HaQue]

SIT! Baracuda SIT!

[mr_spokk]

SIT! Baracuda SIT!

[fzabkar]

See pages 47+ of the following manual:
http://www.rom.by/files/yaxsi_rus-ing_seag_bar.pdf

... and this URL:
http://malthus.zapto.org/viewtopic.php?t=663&p=1896

[galaxy]

Useful Commands

Here we will introduce the useful commands for drive repair and data recovery.
On-line commands:
; display drive Age

. display drive Pgm

% display drive SN

Ctrl+Z turn to COM terminal mode, do not load

overlay

Ctrl+C firmware reset

Ctrl+T restart test for current Age

Ctrl+R load CERT

Common commands:
/x turn to Age x

Interface commands:
Level 2:

2> x view zone table

2>sxxxx,y,22 seek to physical cylinder/head, where xxxx stands for specific cylinder, y for head.

2 >r, x, y read sectors, where x stands for initial sector and y for length.( Attention maximum value of y is 10h considering the capacity of read cache).

2 >w, x, y write sectors, similar to command r.

2 > B x, y display content of cache, where x stands for displayed cache address, y for compared cache address.

2 > I,,, x view and modify adaptive parameters; valid after cert

2 > U spin up motor

2 > Z spin off motor

Level T
T > y view module location

T > V1 view P-list

T > V2 view reserved defect list (T-list)

T > V4 view G-list

T > H clear value of drive Health

T > E4E view selfscan Log

The above commands are valid only when cert is loaded.

T > R load adaptive parameters

Level 8
8 > C20 GC2 repair

Level C
C > D read cert table

Level F
F > R4 load APP from disk to RAM

F > R1 load T-list from disk to RAM

F > j,,22 turn to level T after command R4

[thatdellguy]

Here we will introduce the useful commands for drive repair and data recovery.

I believe your about a decade late to the party...

[HaQue]

Its one thing to know what commands are available, but another thing entirely to know how to use them, and when to use them, and more importantly, when NOT to use them.