Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
May 24th, 2014, 15:21
Hello,
I replace heads, now drive show busy status.
Terminal show
Interface task reset
1024k x 16 SDRAM
TONKA2 - 1_Disk M-31 03-22-06 10:53
Buzz - Head Mask FFFF - Switch to full int.
Spin Ready
(P)PATA Reset
DiskAccess ReadSector EC=47 at ffffffff.00.0000
DiskAccess ReadSector EC=43 at ffffffff.00.0000
Unable To Load Overlay 00|0014
(
T>
How to fix, to recover files.
It's Barracuda 7200.9.
I test on two good drives to replace PSC's and I'm able to Access files.
Is it possible, that also this head is not 100% good
Thank you for any advice
May 24th, 2014, 16:05
Thank you Spildit for your replay,
I have only SD HDD4Seagate and Sediv
May 26th, 2014, 20:11
jerovsek wrote:Hello,
I replace heads, now drive show busy status.
Terminal show
Interface task reset
1024k x 16 SDRAM
TONKA2 - 1_Disk M-31 03-22-06 10:53
Buzz - Head Mask FFFF - Switch to full int.
Spin Ready
(P)PATA Reset
DiskAccess ReadSector EC=47 at ffffffff.00.0000
DiskAccess ReadSector EC=43 at ffffffff.00.0000
Unable To Load Overlay 00|0014
(
T>
How to fix, to recover files.
It's Barracuda 7200.9.
It's either defects in the SA or the donor heads are unable to write due to the difference between them and original ones.
Do the following:
1. Using the drive, create a loader (read appcode only);
2. Load that loader with all the checkboxes enabled except head map editing;
You should get READY and be able to start reading. Should the reading process be slow with interruptions, then install another head stack, current one "isn't compatible enough".
May 27th, 2014, 3:28
Dear Dmitri and Spildit,
thank you very much for your suggestions. I will try.
Best regards
Jure
May 28th, 2014, 2:18
Hello,
right now I try heads from drives which was released between 07066 and 07088.
I have drives released between 07200-07300(right now I don't have it here so date is in this range).
Is worth to try with this or better to find date close to 07066
Best regards
Jure
May 29th, 2014, 21:25
jerovsek wrote:right now I try heads from drives which was released between 07066 and 07088.
I have drives released between 07200-07300(right now I don't have it here so date is in this range).
Is worth to try with this or better to find date close to 07066
Pay attention to the first three characters of the serial number.
May 30th, 2014, 2:03
Thank you Dmitri
BR Jure
Powered by phpBB © phpBB Group.