ST1000lm010 can't read more than 20gb

[nightelf1980]

I can read from the disk until arround 39.000.000 sectors. After that, nothing. I cleaned the smart, no resident G-List, Translator regeneracion, the modules are ok. Had anyone the same problem? Earlier i had the same problem with a Hitachi disk 3.5" that i caoult read until 20Gb.

[labtech]

What was the original problem?

[Matiw]

Is the P-list ok ? Does it have entries ?

I can read from the disk until arround 39.000.000 sectors. After that, nothing. I cleaned the smart, no resident G-List, Translator regeneracion, the modules are ok. Had anyone the same problem? Earlier i had the same problem with a Hitachi disk 3.5" that i caoult read until 20Gb.

[mr_spokk]

I cleaned the smart, no resident G-List, Translator regeneracion.

You did answer it your self

[nightelf1980]

Sorry for my late reply, i did solve the problem. The P-list wasn´t ok even dow it gave me ok. I could´n modify the modules until i made a regen translator without P-list. After i cleaned the G-list, repaired the P-list and once again made a translator regen with P-list this time...i hade access to the sectors.

Strange disk jijiji
Thanks for your replays and sorry again for beeing late

[Madoka]

Thanks for returning to the thread and sharing the solution.

[Matiw]

Hi nightelf1980,


What tool did you use ?

Sorry for my late reply, i did solve the problem. The P-list wasn´t ok even dow it gave me ok. I could´n modify the modules until i made a regen translator without P-list. After i cleaned the G-list, repaired the P-list and once again made a translator regen with P-list this time...i hade access to the sectors.

Strange disk jijiji
Thanks for your replays and sorry again for beeing late

[nightelf1980]

I used a Pc3000