ES2 Seagate drives terminal lock

[S.K.Gulati]

I have got 2 ES2 Seagate drives with model no. ST3250310NS and PCB 100475720 REV A. Out of which 1 is OK and 2 are bad. In case when I connect OK drive I get terminal command by clt Z, but when I connect bad drives I could not excess terminal command and it gives error LED0000.... PCB`s is ok. When I connect only pcb , status becomes ready otherwise the drive show busy only.I have tried to short the pins also but no success.
Please help me what to do?

[Amarbir[CDR-Labs]]

I have got 2 ES2 Seagate drives with model no. ST3250310NS and PCB 100475720 REV A. Out of which 1 is OK and 2 are bad. In case when I connect OK drive I get terminal command by clt Z, but when I connect bad drives I could not excess terminal command and it gives error LED0000.... PCB`s is ok. When I connect only pcb , status becomes ready otherwise the drive show busy only.I have tried to short the pins also but no success.
Please help me what to do?

Gulati ,
Which Tool Are you Using these Days for seagate ? . Though In Terminal Mode It does Not Make any Difference what You Use

[galaxy]

spildit it right . go with spildit

[Amarbir[CDR-Labs]]

spildit it right . go with spildit

Galaxy ,
Where Are You From ?

[S.K.Gulati]

Dear friends,
Thanx for your interest in the post. I tried all the steps which are mentioned in different different posts but could not get terminal command prompt.Even there is one method of shorting the pins ,that also failed.
If Any other suggestion, is welcomed.