ST9750422AS

[unknown]

Terminal log:
EarlySpinup Enabled
Rst 0x10M
(P) SATA Reset

RAW OFF
PASS
APM disabled by SPort
ASCII Diag mode

F3 T>
The drive spin up calibrate normally ( stays busy for approx. 40 sec then ready )
No user area access.
Any thoughts?

Thanks in advance.

[shahij]

what happens when you try to access data area?

[unknown]

what happens when you try to access data area?

After HM creation (All heads (0,1,2,3) shows UNC)
No user area access.

[unknown]

F3 7>X

Head 00 Resistance 019E
Head 01 Resistance 0187
Head 02 Resistance 01AE
Head 03 Resistance 01B1
I think the problem with sys file/s?
But which one?

Thanks in advance.

[jermy]

Code:

F3 T>Ctrl + x

?

[northwind]

Does it load the translator?

[day1data]

Try and open a few sys files like P-List, Translator, NG-List etc.

Is model, serial no and capacity detected?

[unknown]

Does it load the translator?

Try and open a few sys files like P-List, Translator, NG-List etc.

Is model, serial no and capacity detected?

Thanks for replies guys.
Case solved.
Translator issue plus defective H0&H3.

[day1data]

Does it load the translator?

Try and open a few sys files like P-List, Translator, NG-List etc.

Is model, serial no and capacity detected?

Thanks for replies guys.
Case solved.
Translator issue plus defective H0&H3.

Nice work!

[unknown]

Thank you.
good luck

[jermy]

great job, congrats

[unknown]

Thank you Mr. Jermy.
I appreciate your kind help.